The RF300 connects to your Simrad system via .
transmitter lever to its center position using the built-in alignment mark. This mark should be directly opposite the cable entry point. Mount the
The most critical decision you will make is where to mount the RF300. The is clear on the theory: mount it as close to the rudder stock as possible, within a dry, ventilated compartment. However, real-world installations require nuance. simrad rf300 installation manual
or dedicated controller (like an AP44 or AP48) to ensure the system recognizes the
: Mount the RF300 on a stable platform where its center is perfectly in line with the center of the rudder post. Mechanical Linkage : The unit comes with a transmission link assembly. The RF300 connects to your Simrad system via
: Mount the RF300 on a flat platform where the center of the unit is in line with the center of the rudder post. Mechanical Linkage
Installing the Simrad RF300 Rotary Feedback Unit Go to product viewer dialog for this item. Mount the The most critical decision you will
: If you receive a "Rudder Feedback Alarm," double-check that the alignment marks were correctly observed during the center-position setup.