This mode bypasses the standard software security checks, allowing you to read or write the entire flash memory (typically an Am29F800BB or ST10F275 chip).
For most applications, the following pin connections are standard for bench work. Note that there are two main connectors: the smaller 52-pin and the larger 69-pin. Connection Pin Number +12V (Permanent) Pin 3 & Pin 62 Large (69-pin) +12V (Ignition) Large (69-pin) Ground (-) Pin 1 & Pin 2 Large (69-pin) K-Line Large (69-pin) CAN High Large (69-pin) CAN Low Large (69-pin) Draft Post: Bosch ME7.1.1 Bench Guide bosch me711 pinout
These pins are generally consistent for connecting a universal cable to the Bosch ME7.1.1 ECU: +12V (Power): Pins 3, 21, and 62 Ground (GND): Pins 1 and 2 Ignition (+12V switched): K-Line (Communication): Boot Mode Pinout (for Programming) To put the ECU into This mode bypasses the standard software security checks,
To establish a connection for reading or writing (bench mode), the following basic pinout is standard for many Bosch ME7.1.1 variants: Main Ground Permanent Power (+12V) : Pin 62 (often shared with pins 3 and 21 for full wake-up) Switched Ignition (+12V) K-Line Data Communication CAN High/Low Connection Pin Number +12V (Permanent) Pin 3 &
| Pin | Protocol | Note | |------|------------|--------------------------| | 43 | K-Line (ISO 9141) | Diagnostic (7.5V-12V) | | 77 | L-Line (ISO 9141) | Rarely used |
Usually located on the circuit board itself (PCB), often requiring a connection to ground via a resistor depending on the specific tool being used. Lay-by Pins:
Keywords incorporated: bosch me711 pinout, ME7.1.1 wiring, Bosch ME711 connector, Audi 1.8T ECU pinout, bench harness ME711.